Englander Vacuum Switches (PU-VS, CU-VS) and Hose Kit (PU-VH) for All Pellet Stoves & Inserts

Englander Pellet Stove Vacuum Hose and Switch Kit Englander Pellet Stove Vacuum Pressure Hose and Switch Kit, includes 5 feet of hose (way more than enough), clips, and two vacuum switches (PU-VS and CU-VS). Fits ALL England's Stove Works Pellet Stoves to include: Englander, Summers Heat and Timber Ridge, manufactured in 2006 and later. Englander's double auger pellet stoves are some of the most popular pellet stoves in the world (PDV, PDVC models). For E1 code followed by an E2 code at or during startup: On the top or the back of the combustion blower manifold, there is a hose connected to the pressure switch. This hose is made of low-temperature silicon which, dries out overtime where it connects to the manifold and becomes brittle. Air will leak around the hose and this point and the pressure switches contacts will open and trigger the error code. This hose is longer than it needs to be and can be cut a few times. Simply cut off about an inch or somewhere up the hose to a point that’s not brittle and reinsert the hose back on the barb. The vacuum switch sensor needs to see a draw of negative pressure (suction) of at least 0.05" WC (water column) to close the electrical contacts. The vacuum hose from this switch connects directly to the rear of the stove's firebox. The controller DOES NOT read any output from this switch and will not throw any specific code if the switch is not working. In all applications where this switch is used, it is connected to the feed circuit to cut power to the auger motor. In stoves that use two auger motors, it is on the upper auger motor circuit.

• Includes 1 x 5' Hose Length Enough for any Stove + Hose Clamps, 1 x CU-VS Vacuum Switch and 1 x PU-VS Vacuum Switch
• Compatible with all Englander Pellet Stoves (2006 and newer), including: 10-CDV, 10-CPM, 25-CAB80, 25-CB120, 25-CBEP, 25-CBPAH, 25-EP, 25-EPI, 25-IP, 25-PAH, 25-PDV, 25-PDVC, 25-PI (Post: 2006), 25-PUF, 25-SSP01